Remove Seadoo Impeller Without Tool
admin 5/25/2019
Stadium of emirates without exterior and freezes in the master league. Telecharger patch pes 2009 pour 2017 holidays philippines.
dan144k
Jetboaters Lieutenant
Seadoo Impeller Replacement
Sea Doo Drive Shaft Tool / Carbon Seal Tool / OEM # 5. Matrix karaoke. TECSea Doo Drive Shaft Tool. Keygen 2016 download. Aftermarket for OEM part # 5. This tool Fits: Supercharged 4.
Remove Seadoo Impeller Without Tool
- Messages
- 626
- Reaction score
- 319
- Points
- 162
- Location
- Palatine, IL
- Boat Make
- Yamaha
- Year
- 2010
- Boat Model
- AR
- Boat Length
- 24
I have had my impellers on and off several times.
I had sent my port Solas impeller to Impros to get it adjust for a little more low end power, was cavitating bad with weight in the boat.
Went to remove stock impeller (only been installed maybe 4 months) and it was a lot more difficult than in the past. Once apart I found the impeller female threads damaged and also the shaft had damaged male thread. I always used the locktight 567 on the threads like the manual directions show.
(in the future will use a never-seize- I think)
Question:
Anybody know if you can replace the shaft easily?
Does it just slide inside the bearing in the pump housing?
Also, boat is still under warranty with Yamaha.
I spoke with Yamaha service manager and sent him pictures.
He said he would check for me.
I mentioned to him it was a threaded serviceable part and should be able to unscrew without gouging things.
Waiting for a reply, figured I would try.
I had sent my port Solas impeller to Impros to get it adjust for a little more low end power, was cavitating bad with weight in the boat.
Went to remove stock impeller (only been installed maybe 4 months) and it was a lot more difficult than in the past. Once apart I found the impeller female threads damaged and also the shaft had damaged male thread. I always used the locktight 567 on the threads like the manual directions show.
(in the future will use a never-seize- I think)
Question:
Anybody know if you can replace the shaft easily?
Does it just slide inside the bearing in the pump housing?
Also, boat is still under warranty with Yamaha.
I spoke with Yamaha service manager and sent him pictures.
He said he would check for me.
I mentioned to him it was a threaded serviceable part and should be able to unscrew without gouging things.
Waiting for a reply, figured I would try.
JACKOMO
Member
- Messages
- 76
- Likes
- 0
- Location
- Burlington Ontario
- Water Crafts
- 2005 Sea-Doo Sportster LE DI
Skat Trak Impellers
I need to change my wear ring and I am having a hard time getting a hold of the spline tool to remove the impeller on my 2005 Seadoo Sportster Le DI 951. Is there anyway to do it without the tool. The tech in my area said he can order one but its not required all you need to do is use a piece of 2x4.from all the reading I have been doing I can't see another way of removing it, however I see its possible to install a wear ring without removing the impeller. Any suggestions?